HVAC Service Call — Burnt wire and bad breaker in panel
- HVAC
On September 4, 2025, ASSURED HEATING AND COOLING documented HVAC at 10366 Ashbrook Drive, St. Louis, MO 63137.
- Record date
Documented details
- Outcome: Paid in full
Available findings
- HVACCompleted work$219
Service call for no AC: system ran mechanically but tripped the breaker; outdoor unit compressor and fan amps tested fine, and a burnt wire and bad breaker were found in the electrical panel, needing an electrician to install a new 25 amp double pole breaker.
- HVACWork status not resolved
Photograph shows the interior of an electrical panel with a severely burned and charred bus bar or breaker component, with visible scorching, melted material, and heat damage — a significant electrical safety hazard.
- HVACWork status not resolved
Photograph shows the interior of an electrical panel with multiple conductors (red, gray, yellow, white, bare copper) routed in a disorganized manner, a pink paper tag attached to a yellow cable near the panel bottom, circuit breakers along the left side, and debris/dust accumulation at the base of the enclosure.
- HVACWork status not resolved
Photograph shows the interior of an electrical panel with visible charring and burned/melted insulation on a conductor near the breaker bus, indicating a prior or active overheating event; a red wire nut is also visible inside the panel.
- HVACWork status not resolved
Photograph shows a circuit breaker removed from panel lying on a concrete ledge, with visible burn damage and melted insulation on the attached wiring at the connection point.
- HVACWork status not resolved
Photograph shows a Fluke 116 True RMS Multimeter reading 40.1 μF (microfarads) in capacitance mode, being used to test a capacitor on an outdoor AC condenser unit; tools and wiring are visible near the condenser fan grille.
- HVACWork status not resolved
wiring is visible on the right side of the panel
- HVACWork status not resolved