HVAC Replacement Estimate — 3-ton heat pump + 80% furnace, declined
- HVAC
On April 13, 2026, ASSURED HEATING AND COOLING documented HVAC at 524 Rebecca Drive, St. Charles, MO 63301.
- Record date
Available findings
- HVACEstimate or proposed work$11,935
Estimate for Option #1: Equipment Warranty, Payment Terms, Terms and Conditions, Install Description Full 80% (This quote will include the following, fused disconnect, whip and pad for the), 3 Ton 16 Seer Heat Pump R454B (We Propose to install the following equipment in your home).
- HVACWork status not resolved
Photograph shows a Trane XE 90 gas furnace installed in a basement mechanical room, with a black gas supply pipe, red shutoff valve, sheet metal supply plenum, and dual flue/exhaust pipes routed to the ceiling; a yellow EnergyGuide sticker is visible on the lower cabinet.
- HVACWork status not resolved
Photograph shows a furnace or air handler unit with sheet metal plenum and flexible duct boot above, flue pipe to the left, and a tape measure stretched across the unit face reading approximately 23 inches at the far end; an expansion tank and copper piping are visible to the right.
- HVACWork status not resolved
Photograph shows a gas furnace unit with flue/exhaust piping, sheet-metal supply plenum, and large overhead ductwork in a basement mechanical room; a Carrier documentation sheet is affixed to the adjacent duct panel on the left wall.
- HVACWork status not resolved
Photograph shows an outdoor HVAC condenser unit (data plate reads 'XE 1200') installed on a concrete pad close to a brick exterior wall, with refrigerant lines and flexible conduit routed into the structure and a disconnect box mounted on the wall.
- HVACWork status not resolved
Photograph shows a vertical two-section air handler/furnace unit connected to a large sheet-metal supply plenum with a round metal flue duct; a stain or residue is visible on the floor at the base of the unit.
- HVACWork status not resolved
Photograph shows an aged, weathered dual-fan outdoor condenser unit mounted on a concrete pad adjacent to a brick exterior wall, with refrigerant lines and electrical conduit entering the building and a wall-mounted disconnect box; leaf debris is present around the base.
- HVACWork status not resolved
Photograph shows a corroded or aged flexible pipe/hose running along a tile floor beneath a large appliance, with a tape measure indicating approximately 4 inches of clearance at the appliance base; greenish residue or corrosion is visible near the appliance bottom.
- HVACWork status not resolved
- HVACWork status not resolved
Photograph shows an HVAC air handler unit with sheet metal duct transition above; a tape measure is extended across the unit width reading approximately 17 inches, with refrigerant lines visible on the left side.
- HVACWork status not resolved
Photograph shows a vertical air handler cabinet with copper refrigerant lines, black insulation, condensate drain, and sheet metal ductwork
- HVACWork status not resolved
Photograph shows a tape measure extended alongside a sheet metal HVAC air handler or duct enclosure, measuring approximately 25–29 inches in height; a galvanized sheet metal plenum or duct transition is visible at the base on a white tile floor.